Receive mode – Kompernass KH 2022 Uživatelská příručka
Stránka 9

Receive Mode
a) Switching the appliance on/off, button lock
• To switch the appliance on, press on the ...
– button “FM ON”
·
, if you wish to receive VHF transmissions.
– button “AM ON”
»
, if you wish to receive MW or SW 1-7 transmissions.
• The green LED “POWER”
²
glows for as long as the appliance is switched
on.
• To switch the appliance off, press the button “POWER OFF”
¶
.
• With the sliding switch ”HOLD”
ƾ
you can block all buttons against
adjustment (ON), or have them free for adjustment (OFF).
b) Adjusting the reception
• If you have switched the appliance on using the receiving mode button
“AM ON”
»
, first of all select either the reception range MW (Medium
Wave) or SW 1-7 (Short Wave). For this, push the waveband selector
¿
into the relevant position.
• Then search for the desired radio station by slowly turning the tuning re-
gulator “TUNING”
Ƽ
until you have clear reception. In the display
´
the frequency just received is shown digitally, together with the unit
“MHz” (Megahertz) or “kHz” (Kilohertz).
c) Adjusting volume and sensitivity
• Set the desired volume level using the volume regulator “VOL”
ƹ
.
• With MW and SW 1-7 you can adjust the reception sensitivity. Slide the
switch “LOCAL/DX”
ƽ
to the position “LOCAL” if you only want to receive
powerful local transmissions. In the position “DX” the receiver is adjusted
for worldwide reception.
d) Switching the display illumination on
• Hold the button “LIGHT”
Ƹ
pressed down to switch on the display illumi-
nation.
- 7 -
IB_KH2022_AR2503_4b.qxd 26.02.2008 9:41 Uhr Seite 7