Electrolux ESF2450S - Příručka (Stránka 15)

If the water inlet hose is too short, replace
the water inlet hose with an applicable, lon-
ger high-pressure hose. Do not connect an
extension hose.
To suit the installation, it is possible to turn
the end of the hose that is connected to the
dishwasher. Do these steps :
1. Loosen the retaining nut.
2. Turn the hose.
3. Tighten the retaining nut.
Warning! Make sure that the retaining
nut and all other connections are tight
before you move the dishwasher into
position.
Warning! Always use a new water inlet
hose. Do not use connection hoses
from an old appliance.
Drain hose
The appliance has water safety system to
prevent water damage. If there is a malfunc-
tion, the drain pump automatically starts to
drain the remaining water out of the dish-
washer.
Warning! Only if the dishwasher is
connected to the mains socket, the
water safety system operates when the
dishwasher is off.
2 procedures are possible to install the wa-
ter drain hose :
1. Attach the plastic curve supplied at the
end of the hose.
Put the water drain hose in the sink.
2. Connect the water drain hose to the wa-
ter drain system.
The hose must be less than 75 cm
above the bottom of the dishwasher to
prevent incorrect operation of appliance.
If you connect the water drain hose to a
trap spigot under the sink, remove the plas-
tic membrane (A). If you do not remove the
membrane, remaining food can cause a
blockage in the drain hose spigot
electrolux 15