Acer Ferrari 3200 - Příručka (Stránka 92)

Dodatek B Prohlášení o shodě 82
Č
eš
tin
a
2 This equipment is not capable, under all operating conditions, of correct operation at
the higher speeds for which it is designed. Telecom will accept no responsibility should
difficulties arise in such circumstances.
3 Some parameters required for compliance with Telecom's Telepermit requirements
are dependent on the equipment (PC) associated with this device. The associated
equipment shall be set to operate within the following limits for compliance with
Telecom's Specifications:
a
There shall be no more than 10 call attempts to the same number within any 30
minute period for any single manual call initiation, and
b The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next call attempt.
4 Some parameters required for compliance with Telecom's Telepermit requirements
are dependent on the equipment (PC) associated with this device. In order to operate
within the limits for compliance with Telecom's specifications, the associated
equipment shall be set to ensure that automatic calls to different numbers are spaced
such that there is not less than 5 seconds between the end of one call attempt and the
beginning of another.
5 This equipment shall not be set up to make automatic calls to Telecom's 111
Emergency Service.
For Modem with approval number PTC 211/01/030
1 The grant of a Telepermit for any item of terminal equipment indicates only that
Telecom has accepted that the item complies with minimum conditions for connection
to its network. It indicates no endorsement of the product by Telecom, nor does it
provide any sort of warranty. Above all, it provides no assurance that any item will
work correctly in all respects with another item of Telepermitted equipment of a
different make or model, nor does it imply that any product is compatible with all of
Telecom's network services.
2 This equipment is not capable, under all operating conditions, of correct operation at
the higher speeds for which it is designed. Telecom will accept no responsibility should
difficulties arise in such circumstances.
3 This device is equipped with pulse dialing while the Telecom standard is DTMF tone
dialing. There is no guarantee that Telecom lines will always continue to support pulse
dialing.
4 Use of pulse dialing, when this equipment is connected to the same line as other
equipment, may give rise to bell tinkle or noise and may also cause a false answer
condition. Should such problems occur, the user should NOT contact the telecom
Fault Service.
5 This equipment may not provide for the effective hand-over of a call to another device
connected to the same line.
6 Under power failure conditions this appliance may not operate. Please ensure that a
separate telephone, not dependent on local power, is available for emergency use.