Electrolux ESF6211LOW - Příručka (Stránka 70)

9. TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem. With some problems, different indica-
tors flash continuously or intermit-
tently at the same time to show an
alarm code.
Alarm code Problem
• The start indicator flashes continu-
ously.
• The end indicator flashes 1 time in-
termittently.
The appliance does not fill with water.
• The start indicator flashes continu-
ously.
• The end indicator flashes 2 times in-
termittently.
The appliance does not drain the water.
• The start indicator flashes continu-
ously.
• The end indicator flashes 3 times in-
termittently.
The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks. Turn the pro-
gramme knob until the pro-
gramme marker is aligned with the
on/off indicator.
Problem Possible solution
You cannot activate the appli-
ance. Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
The programme does not start. Make sure that the appliance door is closed.
Press the start button.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
The appliance does not fill with
water. Make sure that the water tap is open.
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
70 www.electrolux.com