Panasonic KXTG7150FX - Příručka (Stránka 30)

Useful Information
30
Error messages
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Telephone
Error message Cause & solution
Failed L
Phonebook copy failed. Confirm the other handset
(the receiver) is in standby mode and try again.
Incomplete L
The receiver’s phonebook memory is full. Erase the
unnecessary phonebook entries from the other
handset (the receiver) and try again.
Memory Full L The handset’s phonebook memory is full. Erase
unnecessary entries (page 16).
You must first subscribe
to Caller ID. L
You must subscribe to Caller ID service. Once you
receive caller information after subscribing to Caller
ID service, this message will not be displayed.
Problem Cause & solution
w
is flashing.
L
The handset is not registered to the base unit.
Register it (page 24).
L The handset is too far from the base unit. Move
closer.
L
The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources, such
as antennas and mobile phones.
The handset display is blank.
L
The handset is not turned on. Turn the power on
(page 11).
The handset will not turn on. L Make sure that the batteries are installed correctly
(page 10).
L
Fully charge the batteries (page 10).
L
Clean the charge contacts and charge again (page
10).
I have changed the display
language to a language I cannot
read. L Change the display language (page 11).
TG7150-7170FX(e).book Page 30 Wednesday, January 10, 2007 3:32 PM