2N Door camera for 2N Helios - Installation manual - camera 9135200E, 1701 v2.0 - Příručka (Stránka 3)

2N
®
Helios
color video camera kit
Order No. 9135200E
Description
The 2N ® Helios color video camera kit contains all necessary items for additional
upgrade of your door communicator. It contains an electronic camera module, movable
hinge and the connection cable for the camera and the communicator’s main board. The
video camera is adjustable both vertically and horizontally due to the movable hinge
system. In order to configure the camera use the appropriate connectors (jumpers)
provided in the kit.
!!Warning!!
The video camera shares the power supply with the back light. Before installation make
sure that the parameters of the back light power supply comply with the requirement of
the video camera (see “Technical Parameters” section in the manual). The suitable power
supply is 12V/2A stabilized. It is possible to order this power supply by using order number
91341481E.
In no case use unstabilized or AC power supply (mains transformer)!
Installation
1. Remove metal cover from the door phone.
Remove plastic cover from the base by
unscrewing the screws (4x) located at the
corners.
2.
Remove the black camera cover and replace
it with the clear cover from the “video kit”.
3.
Remove the loudspeaker cradle from the
base by lifting out the pins and pushing the
cradle slightly forward.
4.
Assemble the movable hinge and screw (2x)
it to the base. Place the video camera on the
top of the hinge and use provided screws
(2x) to secure (see the figure below).
5.
Connect the camera with the main board using the provided cable.