Dexaplan GA 617 - Příručka (Stránka 4)

• Do not leave small children unsupervised
with the packaging material. Danger of
suffocation.
• Do not leave children unsupervised with
the device. Danger to life and risk of injury.
• Do not damage any gas, electricity or
telecommunication lines when fitting the
device. Danger to life and risk of injury
and damage.
• Never expose the device to fire, heat or to
temperatures of over 50° C for any length
of time. Danger to life from explosion.
• Make sure that your hearing is not
exposed to the loud alarm signal for any
length of time. This can cause serious
damage to the hearing.
• Make sure that the alarm signal is not
triggered close to the ears. This can
cause serious damage to the hearing.
• Handle the connecting cable with care.
Install it so that it cannot get damaged
and does not create a stumbling hazard.
Otherwise there is danger to life and a
risk of injury and fire.
What to do in the event of a gas leak
Please proceed as follows if the gas alarm sig-
nals a gas leak or if you smell gas:
• Do not ignite any naked lights. Extinguish
any burning tobacco or candles etc.
immediately.
• In the event of a gas leak, do not switch
any electrical devices (light switch, torch,
door bell, telephone, intercom, or other
electric consumers) on or off.
• Do not under any circumstances discon-
nect the gas alarm from the power supply.
• Immediately warn all people at risk and
make sure that they evacuate the area to
safety.
• Shut off the gas supply on the main gas
tap or bottle valve.
• Open the windows and doors and air the
room, the house, the caravan, etc. thor-
oughly.
• Note on airing rooms: certain gases (pro-
pane and butane) are heavier than the
ambient air, and some are lighter (meth-
ane). When airing, please make sure that
the intake of air is suitable for the proper-
ties of the gas.
• If leaking gas is indicated constantly or
repeatedly, please contact your energy
provider. Do not use the telephone or any
other electrical device near or around the
gas leak to notify the provider.
• The gas leak must only be dealt with by a
qualified and authorized expert.
m Caution
• If you are uncertain which type of gas you
use or you have problems installing the
gas alarm you must have the device
installed by a suitably qualified person.
• Only connect the device to 12 V DC!
Check before connecting the 12 V DC
adapter to the mains that the electricity
supply to the device is protected by the
appropriate fuse or trip in accordance
with the applicable regulations.
• This device does not serve as primary
explosion protection as defined by the
guidelines of the employer’s liability insur-
ance associations.
• Do not cover the device with any object. This
could diminish the performance of the sensor.
• Make sure that the device does not come
into contact with moisture.
• Protect the device from strong magnetic
or electric fields.
• Protect the device from heavy mechanical
strain and shocks.
• Only use the device with the supplied
original parts or parts that are designed for it.
• Check before initial operation that all
components are assembled in accord-
ance with the operating instructions.
• Before assembly and initial operation of
the device, check that the contents are
complete and undamaged.
• The device must only be repaired by author-
ized and skilled specialists. Failure to observe
this instruction risks damage resulting from
improper use and loss of the warranty.
• Position the device so that the sensors
can detect escaping gas.
• Only use within the temperature range
specified in the „Technical Data“ section.
Higher or lower temperatures can diminish
performance.
• Do not open the device. Opening the
device will lead to expiry of the warranty.
• For connection in cars, caravans or on
boats, fit the (12 V DC) power supply
cable with a switch approved for this pur-
pose.
• Connect the 12 V DC terminal screws i
either to the mains adapter supplied with
the gas alarm or a 12 V DC power supply
source in cars, caravans and boats. Dual
connection (parallel connection) will dam-
age the mains adapter.
• For connection to the 12 V DC battery, fit
the 12 V DC connecting cable with a fuse
(250 mA).
• Detach the page containing the informa-
tion “IMPORTANT ADVICE” from the oper-
ating manual. Fix this page where it can
be easily seen on the wall directly adja-
7 GB 6 GB
KOE217_GA617_Content_LB4B.indd 6-7 21.11.2007 9:23:41 Uhr