Philco PEC 5406 W - Příručka (Stránka 16)

EN - 14
04/2012 Copyright © 2012, Fast ČR, a. s.
PART 5: MAINTENANCE AND CLEANING
WARNING!
Before cleaning, regular or other maintenance, installation or removal, check that the appliance is
turned off and disconnected from the power socket or that the respective circuit breaker is turned off .
Changing a light bulb
 Turn off the appliance.
 Take out the aluminium fi lter.
 If the light bulb broke during operation wait until it cools down.
 Unscrew the broken light bulb. Install a new one with the same parameters.
Cleaning
 Aluminium fi lters capture dust and fat from the extracted air.
 It is necessary to regularly wash these fi lters, ideally once a month, depending on the level of use. Wash the
fi lters in water with dishwashing detergent, or you may place the fi lters in a dishwasher and wash them
using a gentle program (max. 60°C).
 Take out the aluminium fi lters by pressing the clip.
 After cleaning allow the aluminium fi lters to dry thoroughly before reinstalling them.
 Wipe the outer surface of the range hood with a clean damp wiping cloth lightly dipped in water with
a small amount of dishwashing detergent. Then wipe dry.
 Avoid electrical parts coming into contact with water or another liquid.
 For cleaning you can also use special agents for the maintenance and cleaning of INOX surfaces (applies
only for models with an INOX surface treatment).
WARNING!
For cleaning do not use petrol, benzene, thinners or any other solvents, coarse cleaning agents,
steel wool or any sponges with steel wool.
WARNING!
You may put the aluminium fi lters in a dishwasher. The colour of the aluminium fi lters may change
after several washes. This is a normal event.