Silvercrest SSR 10 A2 - Příručka (Stránka 23)

SilverCrest SSR 10 A2
English - 21
(1), the corresponding alarm symbol (12,13) flashes during
the snooze period. This sequence is repeated until the alarm
tone is switched off. To switch off the alarm tone, briefly press
the "On/Standby" button (6). The alarm is then deactivated
until the next day.
Please note that the signal tone is played via the built-
in buzzer of the scan radio and not via the
earphones.
SNOOZE function
 To pause the alarm tone for approx. 5 minutes, briefly press
the "MODE" button (3) during the signal tone. During these 5
minutes, the corresponding alarm symbol (12,13) flashes on
the display (1) and the "SNOOZE" symbol (15) is indicated.
 After approx. 5 minutes, the alarm tone starts again. To switch
off the alarm tone, briefly press the "On/Standby" button (6).
Storage when not in use
If you will not be using the scan radio for an
extended period of time, remove the batteries to
avoid leakage.
Store the clean device in a dry, cool location.
Troubleshooting
No sound / no reception
 Check whether the earphones (B) are inserted correctly into
the earphone jack (8).
 Check whether the volume is set too low.