Electrolux EGL6382NOX - Příručka (Stránka 53)

and operate the appliance for 10 min.
This is to burn off the residue in the appli-
ance. After that, operate the appliance at
minimum position for 20 min. During this
period, an odour and smoke can occur.
This is normal. Make sure that the airflow
is sufficient.
After this operation, clean the appliance
with a soft cloth soaked in warm water. 4.5 Rapid hot plate
A red dot in the middle of the plate shows
a rapid hot plate. A rapid hot plate heats
up faster than usual plates.
The red dots are painted on the plates.
They can deteriorate during use and even
disappear completely after a period of
time. It does not have an effect on the
performance of the appliance.
5. HELPFUL HINTS AND TIPS
WARNING!
Refer to the Safety chapters.
5.1 Cookware
• The bottom of the cookware
must be as thick and flat as
possible.
WARNING!
Make sure that pots do not cover
the control zone.
5.2 Examples of cooking
applications
Heat
set-
ting: Use to:
1 Keeping warm
2 Gentle simmering
3 Simmering
4 Frying / browning
5 Bringing to the boil
6 Bringing to the boil / quick
frying / deep-frying
5.3 Energy saving
• If possible, always put the lids
on the cookware.
• Put cookware on a solid hot-
plate before you start it.
• Stop the solid hotplate before
the end of the cooking time to
use residual heat.
• For satisfactory results, the di-
ameter of pans and cooking
zones must have the same di-
mensions.
• When the liquid starts to boil, turn down
the flame to barely simmer the liquid.
Use cookware with diameters applicable
to the size of burners.
Burner Diameters of cook-
ware
Rapid 180 - 260 mm
Semi-rapid 120 - 180 mm
Auxiliary 80 - 180 mm
WARNING!
Pots must not enter the control
zone. Flame will heat up the con-
trol zone.
Do not put the same pan on two
burners.
WARNING!
Make sure pot handles do not
protrude over the front edge of
the cooktop and that pots are
centrally positioned on the rings in
order to achieve maximum stabili-
ty and to obtain lower gas con-
sumption.
ENGLISH 53