Panasonic KXTG9120FX - Příručka (Stránka 57)

Useful Information
57
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Telephone
Problem Cause & solution
w is flashing. L The handset is not registered to the base unit.
Register it (page 48).
L
The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L
You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources, such
as antennas and mobile phones.
The handset display is blank.
L
The handset is in screen saver mode (page 13).
Press {ih} to activate the handset display again.
L
The handset is not turned on. Turn the power on
(page 14).
The handset will not turn on.
L
Make sure that the batteries are installed correctly
(page 12).
L
Fully charge the batteries (page 13).
L
Clean the charge contacts and charge again (page
13).
I have changed the display
language to a language I cannot
read. L Change the display language (page 14).
TG9120FX(e).book Page 57 Tuesday, August 29, 2006 9:44 AM