LG F7496QD - Příručka (Stránka 83)

ow to use washer
Child Lock( [Sj )
Medic Rinse
r
&
Pre Wash
If you choose to lock the buttons on the control
assembly to prevent tampering this function may
be selected.
• Child Lock can be set by pressing the Medic
Rinse button and Pre Wash button
simultaneously. (About three seconds)
i p ^ r i
<0‘t_ c
•To deactivate Child Lock system, press Medic
Rinse and Pre Wash buttons simultaneously
again. (About three seconds)
Pre Wash
•To change to the desired program, whilst in
child lock mode.
1. Press both Medic Rinse and Pre Wash
together once again.
(About three seconds)
2. Press the Start/Pause button.
3. Select the desired program and press the
Start/Pause button again.
Change the
desired
program
• The child lock can be set at any time and it can
be deactivated only by using child lock cancel
process. Turning the power off and operafional
errors will nof affecf child lock.
Tub Clean( * )
Intensive
~1
Crease Care
Hr
j
Tub Clean course can be set by pressing and
holding Intensive and Crease Care button
simultaneously.
When Tub Clean course is set, display “ tci. ”■
and all buttons are inoperable.
TUB CLEAN is special cycle to clean the inside
of the washer. This cycle uses higher water level
with higher spin speed. Perform this cycle
regularly.
How to use the Tub Clean cycle:
f. Remove any clothing or items from the washer
and close the door.
2. Open the dispenser drawer and add Anti
limescale (Calgon) to the Main wash
compartment.
NOTE: Do not add any detergent to the detergent
compartments. Excessive suds may
generate and leak from the washer.
3. Close the dispenser drawer slowly.
4. Power On and then press and hold
Intensive and Crease Care button
for 3 seconds, then “ tcL ”displayed in LED.
5. Press the Start/Pause button to start.
6. After the cycle is complete, leave the door
open to dry around the washer door opening,
flexible gaskef and door glass.
A CAUTION: If there is a small child, be
careful not to leave the door
open for too long.