TA Triumph-Adler P-C2160DN - Příručka (Stránka 20)

xviii
Compliance and Conformity
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The use of a non-shielded interface cable with the referenced device
is prohibited.
CAUTION
—
The changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of FCC Rules and RSS-Gen of IC
Rules.
Operation is subject to the following two conditions; (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
* The above warning is valid only in the United States of America.
Konektory rozhraní
DŮLEŽITÉ Před připojením či odpojením kabelu rozhraní zajistěte
vypnutí napájení tiskárny. Na všech nepoužívaných konektorech
rozhraní mějte vždy nasazeny ochranné krytky, které jsou dodávány
jako ochrana proti poškození zařízení statickou elektřinou, jejíž výboj
může proniknout do vnitřních elektronických obvodů tiskárny skrze
konektory rozhraní.
Poznámka Používejte stíněné kabely rozhraní.