Kompernass KH 3236 - Příručka (Stránka 12)

- 8 -
7. Press the button +/= r . Both measurements are added together and
the result is shown in the lower line.
8. Repeat the steps 2 to 7 to add in further measurement values.
9. When you wish to leave the addition mode, press the button MODE 4 .
All values are erased.
Locating concealed objects
Notice:
• Before using the appliance for this task, first test it by locating a pipeline
or electrical power cable at a known position.
• In cases of doubt, always ask a qualified building contractor.
Attention!
Should the appliance find a live wire carrying alternating current,
appears in the display. Under no circumstances should you drill at this
location! Danger of electric shock!
The locating of concealed objects is the same in all three modes (STUD = wood,
AC WIRE = live electric power cables, METAL = metal).
1.
Slide the function switch q to „Detector“.
2. Slide the material switch 3 to STUD, AC WIRE or METAL.
3. First of all, the appliance must be calibrated. Place it flat against the wall
where you wish to search for concealed objects.
4. Press and hold the button PUSH z until the signal tone hums.
The appliance has now adjusted itself to the wall thickness.
Continue to keep the button PUSH
z pressed down.
5. Move slowly along the wall with the appliance. As the arrows in the
display move closer to the centre of the display, you are getting closer
to the concealed object. When the arrows touch and a constant signal
tone is heard, mark this position (see Fig. 4).
IB_KH3236_BN3376_GB_LB4u5 29.02.2008 18:06 Uhr Seite 8