Kompernass KH 3236 - Příručka (Stránka 9)

- 5 -
4. Close the battery compartment t . The battery compartment lid must close
with an audible click.
Measuring distances
1. Slide the function switch q to „Distance“. The display 2 switches itself on.
To switch between the metric and the Anglo-American units of measurement,
press and hold the button MODE
4 . Then press the button READ 6 and release
both buttons simultaneously. When you release the buttons, the measurement
units change.
Note:
Measurements start at the measurement point 1 !
Should the measurement lie outside the measurement range, „Err“ or an illogical
number appear in the display. The measurement range lies between 0,6 m (2“)
and 16 m (53“).
2. Hold the appliance upright towards the wall to which you wish to measure
the distance. The ultrasound sender/receiver
0 must be at a right-angle to
the wall. For this, use the spirit level: The bubble in the glass 8 must stand
between the marking lines (see Fig. 1).
3. Press the button READ 6 . The distance measured appears in the display 2 .
When you hold the button READ 6 pressed down and slowly move the
appliance over the surface to be measured, the appliance continually
measures the distances. These are shown on the display
2 .
Take note of the following illustrations:
Fig. 1 Fig. 2
The further you are from the wall, the wider is the area (a) that the Multi-
Measurement Detector must measure by ultrasound (Fig. 2). Therefore take care
that the Manifold Measurer is always directed at a right angle towards a level
surface (Fig. 1 and 3). Ensure that there are no objects positioned within the
measurement area.
IB_KH3236_BN3376_GB_LB4u5 29.02.2008 18:06 Uhr Seite 5