AEG 86720 - Příručka (Stránka 23)

Operating instructions
23
If washing cycle is completed/remove the washing
Once the washing program has come to an end, L (END) illuminates
on the program progress display.
If o (RINSE HOLD) was selected, the indicator beside the
O/s (START/PAUSE) button flashes.
0 1. After an end rinse the water must first be pumped out:
– Press either the O/s (START/PAUSE) button (the washing will be
spun in accordance with the program that has just been completed;
the spin speed can also be changed during spinning using the SPIN
button),
or
– turn the program selector to C (PUMP OUT), and press the
O/s (START/PAUSE) button (the water is pumped out without spin-
ning),
or
– turn the program selector to D (SPIN) or F (SHORT SPIN), and press
the O/s (START/PAUSE) button (the washing will be spun or short
spun).
At the end of this program step, the L (END) indicator illuminates.
2. Open the fill-in door.
As soon as the indicator beside the K/W (DOOR/LIGHT) button is
green, the door can be opened (not if program protection is activated,
see "Program Protection").
3. Remove the washing.
4. Set program selector to I OFF.
5. Pull the detergent drawer out a little after washing so that it can dry
out. Leave the door ajar so that air can circulate in the washing
machine.
3 If the Å (OVERDOSING) indicator illuminates, then too much deter-
gent was used in the washing program just completed, and as a result
an additional rinse performed. For the next wash observe the detergent
manufacturer’s dosing instructions appropriate to the load!
Attention! If the washing machine is not used for a lengthy period of
time:
Close the tap and disconnect the washing machine from the mains.
(Aqua control with aqua alarm does not function if the washing
machine has been disconnected from the power supply.)