Philco PTF 752 - Příručka (Stránka 8)

EN - 6
12/2011 Copyright © 2011, Fast ČR, a. s.
PART 3: INSTALLATION
Transport and unpacking
If the appliance is transported in a horizontal position the oil from the compressor may leak into the cooling
circuit. For this reason, allow the appliance to rest in a vertical position for 12 hours before turning it on, so that
the oil fl ows back into the compressor.
Remove the external packaging, remove the protective plastic fi lm from the surface of the appliance (if used)
and clean the external parts of the appliance with an agent designed for this purpose. Do not use steel wool or
any coarse agents, which could irreparably damage the surface of the appliance. Carefully remove all papers
and adhesive tape from the appliance, doors and other parts packed in polystyrene. Remove documents and
accessories from inside the appliance.
The packaging material is recyclable and is marked with a recycling symbol. For disposal follow the local
regulations. Packaging materials (plastic bags, polystyrene parts, etc.) must be kept out of the reach of children,
because they present a possible source of danger.
Carefully inspect the appliance. If you discover any faults, stop the installation and contact the vendor.
Operating conditions
The proper operation of the appliance, the freezing temperatures are guaranteed only when the following
conditions are met:
 The temperature in the room where the appliance is located conforms to the climate class stated on the
appliance's rating label.
 Maximum ambient relative humidity: 90%.
 The appliance must be placed at a suffi cient distance from heat sources (e.g. baking ovens, central heating,
direct sunlight, etc.).
 The appliance must be located in such a place that it is protected against weather eff ects.
 Regular maintenance is performed according to the instructions in this user's manual.
 The ventilation openings in the cover of the appliance must not be covered by anything.
 Correct installation (e.g. levelling, the capacity of the system correspond to the specifi cations on the rating
label of the appliance).
Table – Climatic class
Climatic class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
PART 3: INSTALLATION