Philco PEB 644 IX - Příručka (Stránka 8)

EN - 6
04/2012 Copyright © 2012, Fast ČR, a. s.
Supplied accessories (depending on the model)
A non-return exhaust fl ap must be installed into the air outlet of the range hood (unless one is already factory
installed).
This part is not included, it must be purchased separately.
Placement
Install the range hood at a height of at least 65 cm above an electric cooktop or at a height of 75 cm above
a gas cooktop.
IMPORTANT:
Before installing or using the appliance, please fi rst read all instructions and check that the voltage and
frequency values on the rating label correspond to the voltage and frequency in your electricity grid.
We recommend that the appliance be connected by a service technician or another qualifi ed person in
compliance with local codes and regulations.
Before starting the installation
 Check that the purchased appliance has the correct dimensions corresponding to the chosen installation
location. Furthermore ensure that there is an electrical power socket available that will remain accessible
even after the range hood is installed.
 Before installing the range hood, check that all necessary masonry work is complete.
 Have all electrical connections performed by a qualifi ed person.
 We recommend that you remove the aluminium fi lters before installing the range hood.
 Check that there are no packaging materials or other materials, e.g. user’s manual, warranty card or bags
with screws, inside the appliance. These need to be taken out and kept for possible use in the future.
 We recommend that you disconnect and move to the side freely standing or built in stoves so that you
have easier access to the rear wall or ceiling. If this is not possible place protective material on to the work
area, cooktop or stove. This will prevent damaging these surfaces.