Philco PEW 9742 A - Příručka (Stránka 10)

EN - 8
02/2014 Copyright © 2014, Fast ČR, a. s.
2. Installation of the non-return exhaust fl ap
Install the non-return exhaust fl ap on to the top part of the range hood using 3.5 x 9.5 screws according to
the illustration below.
3.5 x 9.5 screws
3) Drilling mounting holes
Place the installation template against the wall and drill holes in points A, B, C using a drill bit with
a diameter of 10 mm. To install the chimney, drill holes using a drill bit with a diameter of 6 mm adhering
to the dimensions for the minimum and maximum height.
WARNING!
When drilling the mounting holes used for hanging the range hood, ensure the holes have the
correct diameter. If the holes are drilled incorrectly, then the correct assembly of the range hood
will not be possible.
4) Inserting dowels
Into the drilled holes A, B, C with a diameter of 10 mm, insert dowels with a diameter of 10 mm. Into the
two holes with a diameter of 6 mm, insert dowels with a diameter of 6 mm – see illustration below.
10mm plastic dowel 6mm plastic dowel