Philco PEW 9743 T - Příručka (Stránka 18)

EN - 16
2014 02/2014
PART 5: MAINTENANCE AND CLEANING
Warning:
Before cleaning, regular or other maintenance, installation or removal, check that the appliance is
turned off and disconnected from the power socket or that the respective circuit breaker is turned
off .
Changing a light bulb
• Turn off the appliance.
• Take out the aluminium fi lter.
• If the light bulb broke during operation wait until it cools down.
MODELS WITH A 20 W LIGHT BULB
To remove the halogen light bulb (20 W), fi rst remove the glass cover using a thin screwdriver. Be careful not
to scratch the appliance. Remove a faulty light bulb by pulling downwards and insert a new working light
bulb.
Use a light bulb with the same parameters.
Note:
Do not hold the light bulb with your bare hands. Dirt or sweat from the hand may shorten
their lifetime.
Cleaning
• Aluminium fi lters catch dust and fat from the extracted air.
• It is necessary to regularly wash these fi lters, ideally once a month, depending on the level of use. Wash the
fi lters in water with dishwashing detergent, or you may place it in a dishwasher and wash using a gentle
program (max. 60°C).
• Take out the aluminium fi lters by pressing the clip.
• After cleaning allow the aluminium fi lters to dry thoroughly before reinstalling them.
• Wipe the outer surface of the range hood with a clean damp wiping cloth lightly dipped in water with a
small amount of dishwashing detergent. Then wipe dry.
• Avoid electrical parts coming into contact with water or another liquid.
• For cleaning you can also use special agents for the maintenance and cleaning of INOX surfaces (applies
only for models with an INOX surface treatment).