Philco PEW 9743 T - Příručka (Stránka 4)

EN - 2
2014 02/2014
PART 1: IMPORTANT SAFETY INSTRUCTIONS
Safety notice
Symbols:
General advice for the optimal operation of the appliance
General dangers
Recommendation:
Carefully read these instructions before installing and operating this range hood.
Write down the serial number found on the rating label of the range hood in the space below. It is
essential that you store this user's manual in a safe place so that you can use it in the future. If you
intend to sell the appliance, give it to another owner, or if you move, always make sure that the user's
manual is attached to the appliance, so that the new owner can also learn about the operation of the
appliance and the relevant warnings.
SERIAL NUMBER:
Important safety instructions
• This appliance is designed for household use only.
• Before connecting the power cord plug, make sure the voltage stated on the rating label of the appliance
corresponds to the voltage in your wall socket. Connect the power cord plug to a power socket with a
voltage of 220 – 240 V ~ 50 Hz.
• Only use a properly grounded power socket. The appliance may only be connected to a properly grounded
power socket.
• All electrical connections must be performed by a qualifi ed electrician.
• Installation performed by an unqualifi ed person may cause incorrect operation, damage to the appliance,
create a fi re hazard or cause injury to persons.
• Neither the manufacturer nor the vendor take responsibility for damages cause due to an incorrect or
unprofessional installation, connection or operation. Tampering with the appliance by an unqualifi ed
person will void the customer's right to a warranty repair.
• Do not expose to power cord to excessive pressure or loads, do not place heavy objects on it, it must not
be tangled and it must not be stepped on. Do not locate the power cord in or on heat sources such as
stoves, heating or other generators of heat. Otherwise this may damage the power cord or create a fi re
hazard.
• Only connect the power cord plug to a power socket after the entire installation is completed.
• The power plug serves as a disconnection device and for this reason the power socket must remain easily
accessible for the event of a dangerous situation, unless it is connected into a terminal box.
• Do not touch the lights if the appliance has been running for some time. Lights heat up during operation
and may cause burns.