Philco PW 12 - Příručka (Stránka 7)

EN - 5
01/2012 Copyright © 2012, Fast ČR, a. s.
PART 3: INSTALLATION
Transport and unpacking
Remove the external packaging, remove the protective plastic fi lm from the surface of the appliance (if used)
and clean the external parts of the appliance with an agent designed for this purpose. Do not use steel wool or
any coarse agents, which could irreparably damage the surface of the appliance. Carefully remove all papers
and adhesive tape from the appliance, door and other parts packed in polystyrene. Remove documents and
accessories from inside the appliance.
The packaging material is recyclable and is marked with a recycling symbol. For disposal follow the local
regulations. Packaging materials (plastic bags, polystyrene parts, etc.) must be kept out of the reach of children,
because they present a possible source of danger.
Carefully inspect the appliance. If you discover any defects, stop the installation and contact the vendor.
Operating conditions
Proper operation of the appliance is guaranteed only if the following conditions are met:
•
The temperature in the room where the appliance is located conforms to the climate class stated on the
appliance's rating label.
• Maximum ambient relative humidity: 90%.
• The appliance must be placed at a suffi cient distance from heat sources (e.g. baking ovens, central heating,
direct sunlight, etc.).
• The appliance must be located in such a place that it is protected against the eff ects of weather.
• Regular maintenance is performed according to the instructions in this user's manual.
• The ventilation openings in the cover of the appliance must not be covered by anything.
• Correct installation (e.g. levelling, the capacity of the system corresponds to the specifi cations on the
rating label of the appliance).
Table – Climatic class
Climatic class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C;
ST +16°C to +38°C
T +16°C to +43°C
Placement
The location for the placement of the appliance must meet the requirements in the paragraph "Operating
conditions" and must have a stable fl oor with a load bearing capacity corresponding to the weight of the appliance.
Level the appliance using the levelling feet, ensure there is a gap between the bottom edge of the appliance
and the ground, so that there is suffi
cient circulation of the cooling air, by which you will ensure the optimal
performance of the cooling circuit.