Philco PW 12 - Příručka (Stránka 8)

EN - 6
01/2012 Copyright © 2012, Fast ČR, a. s.
• Use the appliance only for the purposes for which it has been designed.
• The appliance must be located on a rigid and even surface.
• If possible, place the appliance into a cool, well ventilated and dry room.
• Do not locate the appliance in direct sunlight, or in a room with a high temperature, in the vicinity of any
sources of direct heat, such as heating, an oven, a stove, etc.
If it is not possible to prevent the installation in the vicinity of a heat source, we recommend the insertion of an
appropriate insulating board (do not use asbestos) between the appliance and the heat source; or at least to
maintain the following minimum distances:
• From a gas or electric stove 3 cm;
• From a heater or oven, etc. 30 cm;
• From another cooling appliance 2 cm.
Do not place any appliances on the appliance, which release heat on to the appliance, such as microwave
ovens, toasters, etc.
Never cover the ventilation grill. Pull out the power plug by pulling on the plug itself, never pull on the cord
when disconnecting the appliance.
Before turning on the appliance allow it to stand in its fi nal location for 12 hours. Before connecting
the appliance to the power grid check that it is perfectly dry inside – especially in the corners.
Danger warning
Any unqualifi ed tampering with the product may cause a fi re hazard.
Only professionally qualifi ed persons may work on the cooling system.
Cleaning before use
Check that you have removed from the appliance all adhesive tape used to hold accessories . Then clean all the
inside parts using lukewarm water with a neutral cleaning agent, vinegar or sodium carbonate – in this way
you will remove the characteristic odour of new parts – then dry carefully. Do not use detergents or aggressive
agents, which could damage the surfaces.