Philips AX5011 - Příručka (Stránka 11)

IN-CAR CONNECTION
19
Only use the AY 3545 car
voltage converter (4.5V, DC,
positive pole to the centre pin)
and the AY 3501 car cassette
adapter. Any other product may
damage the set.
1 Put the CD-player on a
horizontal, vibration-free and
stable surface. Make sure it
is in a safe place, where the
player is neither a danger nor obstacle to either driver or passenger.
2 Connect the DC plug of the voltage converter to the 4.5V DC socket of the CD-
player (only for a 12 V car battery, negative grounding).
3 Insert the voltage converter into the cigarette lighter socket. If necessary, clean the
cigarette lighter socket to obtain a good electrical contact.
4 Turn down the volume and connect the cassette adapter plug to the LINE OUT/p
socket of the CD player.
5 Carefully insert the cassette adapter into the car radio’s cassette compartment.
6 Make sure the cord does not hinder your driving.
7 Start the CD-player, set VOL E to position 8 and adjust the sound with the car
radio controls.
• Always remove the voltage converter from the cigarette lighter socket when the
CD-player is not in use.
Note: – Avoid excessive heat from the car heating or from direct sunlight (e.g. in a
parked car in the summer).
– If your car radio has a LINE IN socket, it is better to use this instead of the
cassette adapter. Simply connect a signal lead from the LINE OUT/p socket
of the CD-player to this LINE IN socket.
4,5 V DC
DIGITAL DIGITAL DIGITAL
ESP
BASS
LIN E OU T/
O FF • R ES U M E • H O LD
PROGRAM
MODE
In-car use (connections supplied or optionally available)
English
FEATURES
18
Conventional portable CD-players subjected to a shock
or vibration during playback often skip parts of the CD. The
ELECTRONIC SKIP PROTECTION (ESP) feature, with which
your set is equipped, however, prevents such loss of
continuity when your player is subjected to light vibrations.
But ESP does not prevent playback interruptions caused by
vigorous exercise. Nor does it protect against damage
resulting from the player being dropped!
• Press ESP during playback to activate the skip
protection.
y ESP is shown and the protection is activated.
• To deactivate the skip protection, press ESP again.
y ESP goes off and the protection is deactivated.
ESP English
Perf/14 eng 5/6/01 14:32 Page 18