Power supply – Philips AX5011 Uživatelská příručka

Stránka 6

Advertising
background image

POWER SUPPLY

9

Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH
battery AY 3362.

Recharging the ECO-PLUS NiMH battery on board
1
Insert the rechargeable ECO-PLUS NiMH battery AY 3362.

2 Connect the mains adapter to the 4.5V DC socket of

the player and then to the wall socket.

y

A is shown and ChArGE is displayed for 5
seconds.

• Recharging stops after a maximum of 7 hours, or when you start playback.

3 When the battery is fully recharged,

and

FULL appear briefly in the display, before the
display switches off.

Notes: – It is normal for the batteries to become warm during recharging.

– If the batteries become too warm, recharging will be interrupted for

approximately 30 minutes and Hot is displayed.

– To ensure proper recharging on board, take care that contacts are clean.
– Use only the ECO-PLUS NiMH battery AY 3362.

Handling instructions
• Recharging already charged or half-charged batteries will shorten their lifetime.

We therefore recommend that you let the rechargeable ECO-PLUS NiMH battery
run till it is completely empty before you recharge it.

• To avoid a short circuit, do not let the battery touch any metal object.

• If the battery becomes empty soon after recharging, then either its contacts are

dirty or it has reached the end of its lifetime.

ECO-PLUS NiMH battery information

(for versions supplied with

the rechargeable ECO-PLUS NiMH battery AY 3362)

English

English

POWER SUPPLY

8

You can use the following batteries with this CD-player:
• normal batteries type LR6, UM3 or AA (preferably Philips), or
• alkaline batteries type LR6, UM3 or AA (preferably Philips).

Note: – Old and new or different types of batteries should not be used in

combination. Remove batteries if they are empty or if the player is
not going to be used for a long time.

Inserting batteries
1
Push OPEN

2 to open the CD lid.

2 Open the battery compartment and insert either

2 normal or alkaline batteries, or the rechargeable
NiMH battery AY 3362 (if supplied).

Battery charge indication
The approximate power level of your batteries is shown in the display.

Battery full
Battery two-thirds full
Battery one-third full
Battery dead or empty. When the batteries are
dead or empty, the symbol

A flashes, bAtt is

displayed, and the beep tone sounds repeatedly.

Average playing time of batteries under normal conditions
Battery type

ESP on

ESP off

Normal

7 hours

6 hours

Alkaline

22 hours

19 hours

Rechargeable ECO-PLUS NiMH battery

10 hours

9 hours

Batteries contain chemical substances, so they should be disposed
of properly.

Batteries

(supplied or optionally available)

Perf/14 eng 5/6/01 14:32 Page 8

Advertising
Tato příručka se vztahuje na následující produkty: