Sony HT-ST3 - Příručka (Stránka 8)

8
GB
Installing the Bar Speaker on a wall
You can install the Bar Speaker on the wall.
 Use screws that are suitable for the wall material and strength. As a
plaster board wall is especially fragile, attach the screws securely to a wall
beam. Install the Bar Speaker on a vertical and flat reinforced area of the
wall.
 Be sure to subcontract the installation to Sony dealers or licensed
contractors and pay special attention to safety during the installation.
 Sony is not responsible for accidents or damage caused by improper
installation, insufficient wall strength, improper screw installation or
natural calamity, etc.
1
Prepare screws (not supplied) that are suitable for the holes
on the back of the Bar Speaker.
2
Fasten the screws to the wall.
The screws should protrude 8 to 9 mm.
3
Stick the cushions supplied on the back of the Bar Speaker.
Notes
Hole on the back of the Bar Speaker
4 mm
More than 30 mm
4.6 mm
8.5 mm
8 to 9 mm
300 mm
Cushion Cushion
20 mm 20 mm
5 mm 5 mm