Philco PBC 6027 - Příručka (Stránka 11)

EN - 9
06/2012 Copyright © 2012, Fast ČR, a. s.
PART 4: CONTROLS
Each compartment of the appliance (left and right) is controlled independently.
Insert the power plug into a properly grounded power socket.
If the power supply is interrupted, the previously set temperature will be automatically deleted and the factory
set temperature will be set.
7 °C - Left compartment
12 °C - Right compartment
Setting the temperature
Use the up/down buttons to set the desired temperature of the appliance. Each time the up/down buttons are
pressed, the temperature will increase/decrease by 1 °C. The set temperature will fl ash on the LED display for
5 seconds, then the temperature inside the appliance will be shown.
Both compartments: You can set the temperature in the range from 5 °C to 18 °C.
To show the set temperature, press and hold the respective button for about 5 seconds and the set temperature
will fl ash on the screen for about 5 seconds.
Flashing LED indicator light = Set temperature
Lit LED light = Temperature inside the appliance
Racks
• To prevent damaging the doors or gasket seals, open the doors wide open when removing the racks.
• For easier handling of bottles, it is necessary to pull the rack out by at least a 1/3. The sides of the racks are
equipped with protective stoppers, which prevent bottles from falling from the racks.
When removing / inserting the racks from / into the rails, lift one side of the rack as shown in the picture below
and pull the rack out towards yourself, or push it in when inserting it, until one side is securely seated in the rail.