Philco PBC 6027 - Příručka (Stránka 9)

EN - 7
06/2012 Copyright © 2012, Fast ČR, a. s.
Placement
The location for the placement of the appliance must meet the requirements in the paragraph "Operating
conditions" and must have a stable fl oor with a load bearing capacity corresponding to the weight of the
appliance.
This appliance is may be built-in.
In such a case, adhere to the dimensions below.
From the front From the side From above
Level the appliance using the adjustable feet, ensure there is a gap between the bottom edge of the appliance
and the ground, so that there is suffi
cient circulation of the cooling air, by which you will ensure the optimal
performance of the cooling circuit.
• Check whether any cooling circulation pipes have been damaged during the installation.
• Use the appliance only for the purposes for which it has been designed.
• The appliance must be located on a rigid and even surface.
• In this way you will ensure free circulation of the coolant and eff ective operation of your appliance.
• If possible, place the appliance into a cool, well ventilated and dry room.
• Do not locate the appliance in direct sunlight or in a room with a high temperature, in the vicinity of any
sources of direct heat, such as heating, an oven, a stove, etc. – this would mean that the compressor would
need to work a lot harder resulting a substantially higher power consumption level.
If it is not possible to prevent the installation in the vicinity of a heat source, we recommend the insertion of an
appropriate insulating board (do not use asbestos) between the appliance and the heat source; or at least to
maintain the following minimum distances:
• From a gas or electric stove 3 cm;
• From a heater or oven, etc. 30 cm;
• From another cooling appliance 2 cm.