Built-in, Draining water, Extending the hose – Philco PD 1261 BIB Uživatelská příručka
Stránka 11: Connecting the drain hose
EN - 9
10/2012
Copyright © 2012, Fast ČR, a. s.
Draining water
Connect the drain hose. The drain hose must be properly attached so that water does not leak. Check that
the hose is not knotted up or pinched.
Extending the hose
If you need to extend the drain hose, you must use the same type of drain hose.
The hose must not be longer than 4 meters. Otherwise the effi ciency of the dishwasher would be reduced.
Connecting the drain hose
You must connect the drain hose at a height from 50 cm (minimum) to 110 cm (maximum) from the bottom
part of the appliance. Secure the drain hose using a clamp. The loose end must not be submerged in water.
Built-in
This dishwasher is designed to be built-in. Adhere to all warnings and instructions contained in this user‘s
manual during installation.
Before installation check that the required dimensions of the dishwasher to be built-in correspond to the
dimensions of the installation location – see illustration below.