Philco PD 1261 BIB - Příručka (Stránka 35)

EN - 33
10/2012 Copyright © 2012, Fast ČR, a. s.
Error codes
Error code Description Possible causes
Wash
(Washing)
Rinse
(Rinsing)
Dry
(Drying)
End
(End)
Start/
Pause
Insuffi cient
water supply
Check that the water inlet is fully
open and that the water supply was
not interrupted.
Shut off the water inlet. Unscrew the
water supply hose and clean out the
fi lter on the end of the hose.
Restart the dishwasher, contact an
authorised service centre.
Water supply
failure
Shut off the water inlet.
Contact an authorised service
centre.
It is not
possible
to pump
residual water
out of the
dishwasher.
The drain hose is clogged.
The fi lters may be clogged.
Turn off the dishwasher and turn on
the cancel wash programs.
If the problem persists contact an
authorised service centre.
Heat
malfunction
Contact an authorised service
centre.
The warning
indicator light
is activated
when the
dishwasher
overfl ows.
Turn off the dishwasher and close
the water inlet.
Contact an authorised service
centre.
Faulty
electronic
card
Contact an authorised service
centre.
Overheating
malfunction
(the
temperature
of the
dishwasher is
too high)
Contact an authorised service
centre.
Heat sensor
error
Contact an authorised service
centre.
WARNING!
 In the event that the dishwasher becomes fl ooded, close the water supply before calling the
service technician.
 If as a result of fl ooding or a water leak there is water in the bottom container, pour it out
before turning on the dishwasher again.