Adding salt into the salt container, Setting salt consumption, En - 13 – Philco PD 1261 BIB Uživatelská příručka
Stránka 15
EN - 13
10/2012
Copyright © 2012, Fast ČR, a. s.
Setting salt consumption
The dishwasher is designed to enable the adjustment of salt consumption on the basis of the hardness of the
water used. This should optimise and adapt the level of salt consumption.
Table for setting up water hardness
Water hard-
ness level
dH
(German unit)
dF
(French unit)
dE
(English unit)
Water hardness setting indicator
1
0 – 5
0 – 9
0 – 6
The washing indicator will turn on.
2
6 – 11
10 – 20
7 – 14
The rinsing indicator will turn on.
3
12 – 17
21 – 30
15 – 21
The drying indicator will turn on.
4
18 – 22
31 – 40
22 – 28
The end of program indicator will turn on.
5
23 – 31
41 – 55
29 – 39
The washing and end of program indicator
will turn on.
6
32 – 50
56 – 90
40 – 63
The rinsing and end of program indicator
will turn on.
1. While the appliance is turned off , turn the program selection dial to position 0 (Reset).
2. Press and hold the Start/Pause button.
3. Meanwhile press the On/Off button.
4. Hold down the Start/Pause button until the program progress buttons start fl ashing.
5. As soon as the icons „3h-6h-9h-12h“ start fl ashing, release the Start/Pause button.
6. Repeatedly press the Start/Pause button to set the water hardness level.
7. To confi rm and save into the dishwasher‘s memory press the On / Off button.
NOTE:
Your water supplier will provide you with information about the hardness of your water.
CAUTION!
If your dishwasher does not have a water softening system, you can skip this chapter.
Adding salt into the salt container
Always use salt designed for dishwashers.
The salt compartment is located under the lower rack and you should refi ll it in the following manner.
NOTE
Use only salt specifi cally designed for use in dishwashers! Any other kind of salt, which is not
specifi cally designed for use in dishwashers, particularly table salt, would damage the softener
system in the dishwasher. Damage caused by the use of inappropriate salt is not covered by
the manufacturer's guarantee and the manufacturer takes no responsibility for any damages
caused.
Add the salt before starting one of the full washing cycle programs. This will prevent salt
crystals or salt water from lying at the bottom of the dishwasher, where this could lead to
corrosion.