Philco PEI 4701 - Příručka (Stránka 10)

EN - 8
04/2012 Copyright © 2012, Fast ČR, a. s.
NOTE:
The part on the appliance marked "FRONT" indicates the position where the control panel will be located.
4. Installation of the hanging plate
Place the motor unit on the ceiling and mark the points for drilling holes for the screws. Into the designated
locations A, B, C, D drill 10mm holes for screws. Depending on the surface of the ceiling use an appropriate
drill bit size.
5. Inserting dowels
Insert dowels into the drilled holes A, B, C, D. Check that the dowels are properly inserted.
6. Inserting screws
Insert screws (5.5 x 45) into the dowels and leave a 5mm gap between the ceiling and the screw head.
7. Attaching the motor unit
Lift the motor unit and slide the screws through the holes in the top part. Check that all screws are in their
respective holes. Turn the motor unit clockwise to secure the motor unit in place.