Philco PEI 4701 - Příručka (Stránka 9)

EN - 7
04/2012 Copyright © 2012, Fast ČR, a. s.
 It is necessary that a qualifi ed technician inspects the suitability of the supplied fastening material and
other components for the specifi c wall / ceiling type. The wall / ceiling must be suffi ciently strong to hold
the weight of the range hood.
 Do not attach this range hood to a wall or cabinet furniture by tiling, plastering and do not glue it on using
silicone glue. The appliance is designed to only be installed on a wall / ceiling.
 We recommend that always two people perform the installation of the appliance.
If your range hood is designed to be mounted to the ceiling, adhere to the following instructions.
1. The range hood must only be suspended on ceiling beams or on load bearing ceiling beam connections.
2. Do not suspend the range hood on false ceilings.
3. The
ceiling must have a load bearing capacity of at least 40 kg.
4. The ceiling thickness must be at least 30 mm.
IMPORTANT:
THE RANGE HOOD MAY ONLY BE CONNECTED TO THE ELECTRICAL GRID AFTER THE ENTIRE INSTALLATION
IS COMPLETE.
NOTE:
The pictures are only for your reference. These are subject to changes and could be used for more models.
1. Removing the separating plate
To remove the separating plate, pull it down holding the right and left top part.
NOTE:
Check that the distance between the motor unit and a gas stove is at least 84 cm and at least 94 between
the motor unit and an electric stove.
2. Take the motor unit out of the packaging.
3. Measuring
distances
Take the screws out of the motor unit (see below) and assemble the location of the motor unit, which
consists of two blocks by sliding in or out.
Then put the screws back.