Philco PEI 4701 - Příručka (Stránka 16)

EN - 14
04/2012 Copyright © 2012, Fast ČR, a. s.
Cleaning
 Aluminium fi lters capture dust and fat from the extracted air.
 It is necessary to regularly wash these fi lters, ideally once a month, depending on the level of use. Wash the
fi lters in water with dishwashing detergent, or you may place the fi lters in a dishwasher and wash them
using a gentle program (max. 60°C).
 Take out the aluminium fi lters by pressing the clip.
 After cleaning allow the aluminium fi lters to dry thoroughly before reinstalling them.
 Wipe the outer surface of the range hood with a clean damp wiping cloth lightly dipped in water with
a small amount of dishwashing detergent. Then wipe dry.
 Avoid electrical parts coming into contact with water or another liquid.
Cleaning the aluminium fi lters
The aluminium fi lters need to be cleaned when "C" appears on the display (depending on the model).
Clean the fi lters according to the above mentioned instructions and after reinstalling them press and hold
down the
button for 3 seconds until the "C" symbol (depending on the model) disappears from the display.
The symbol "E" (depending on the model) will appear on the display, which means that the appliance is ready
for operation.
If you wish to use the appliance without clearing the "C" symbol (depending on the model), press the
button to start extraction for 1 second, then the "C" symbol (depending on the model) will appear again and
the motor will continue running.
NOTE:
The "C" symbol (depending on the model) appears on the display after approximately 60 hours
of operation.
WARNING!
For cleaning do not use petrol, benzene, thinners or any other solvents, coarse cleaning agents,
steel wool or any sponges with steel wool.
WARNING!
You may put the aluminium fi lters in a dishwasher. The colour of the aluminium fi lters may change
after several washes. This is a normal event.