Philco PLD 1061 M - Příručka (Stránka 8)

EN - 6
10/2014 Copyright © 2014, Fast ČR, a. s.
PART 2: INSTALLATION
Removal of the transportation screws
• You must remove the transportation screws located in the back part of the washing machine before
putting it into operation.
• Loosen the screws using a correctly sized spanner, by turning them anticlockwise.
• Remove the screws by pulling them out.
• Insert plastic plugs found in the accessories pouch, into the transport screw holes.
• Carefully store the transportation screws removed from the washing machine for future transport purposes.
NOTE:
Defects caused by starting the washing machine with the transportation screws installed are not covered
by the warranty.
Levelling the washing machine
•
Do not place the washing machine on carpets or similar surfaces.
• To ensure quiet and vibration free operation of your washing machine, you should place it on an even,
non-slip and fi rm surface.
You can level the washing machine by adjusting the adjustable feet:
•
First loosen the plastic nut.
• Adjust by screwing out the feet upwards or downwards.
• After levelling the washing machine, re-tighten the plastic nut by screwing it upwards.
• Never level the washing machine on an uneven surface by placing cardboard, wooden blocks, etc. under
the feet.