Philco PLA 1483 - Příručka (Stránka 24)

EN - 22
01/2011 Copyright © 2011, Fast ČR, a. s.
The water inlet fi lters
There are fi lters connected to the hose ends at the tap end and at the end of the inlet valves, which prevent dirt
and foreign materials contained in water entering the washing machine. If the washing machine is not fi lling
up with a suffi
cient amount of water despite the water inlet being open, clean these fi lters.
• Disconnect the supply hose.
• Using tweezers take the fi lters out of the inlet valves and wash them with a brush.
• Using your hand take out the fi lters on the supply hoses at the end connected to the tap together with the
seals and clean them.
• After cleaning the fi lters put them back in the same way.
Attention:
The water inlet valves may be blocked by a contaminated water supply or because of inadequate
necessary maintenance, or the valves may be damaged, which may cause a water to constantly
fl ow through. For these reasons such types of malfunctions are not covered by the warranty.
The pump fi lter
The pump fi ltration system extends the life of the pump, which is used for draining dirty water. It ensures that
lint from the laundry does not enter the pump. We recommend you clean the pump fi lter every 2-3 months.
Clean the pump fi lter as follows:
• Open the cover on the kickplate.
• Before opening the fi lter cover, place a container in front of it, into which the water remaining in the
washing machine will fl ow.
• Loosen the fi lter cover by turning it anticlockwise and drain the water.
• Remove all foreign material from the fi lter.
• Check by hand that the pump rotates.
• After cleaning the pump, return the fi lter by turning it clockwise.