Philco PLD 1273 Crown - Příručka (Stránka 19)

EN - 17
04/2015 Copyright © 2015, Fast ČR, a. s.
The main function can be selected as follows:
- Prewash
The Prewash function can get an extra wash before main wash.
- Speed
Wash
The function can decrease the washing time.
- Extra
Rinse
The laundry will undergo extra rinse once after you select it.
- Delay
Delay function can be set with this button, the delaying the time is 0-24h.
Set the delay function:
1. Select
a procedure;
2. Press the Delay button choose the time;
3. Press Start/Pause to commence the Delay operation.
Cancel the Delay function:
Press the Delay button until the display will to be 0h.
Notes: If there is any break in the power supply while the machine is operating, a special memory stores the
selected programme and when the power is restored, it continues where it left off .
- Reload
This operation can be executed during the washing procedure. When the drum of the washing machine is still
rolling and there is large amount of water with high temperature in the drum. The state is unsafe and the door
cannot be opened forcefully. To press ddd Start/Pause eee for 3 sec. to reload, and start the clothes adding in the
midway function.
Please follow the steps as bellow:
1. Wait until the drum stops rotation.
2. The door lock is unlocked.
3. Close the door when the clothes needs are loaded and repress the «Start/Pause». button.
- Child
Lock
To avoid that the washing procedure cannot operate normally due to the mis operation by kids during the
washing procedure, you can select this function, In this case, the other buttons except On/Off button can not
work, at this state ,the machine power off when press the key on/off . The machine remembers the program child
lock and the program during powered off when press the key on/off again.
Press Rinse and Pre Wash together 2.5 seconds during the running procedure, the buzzer will beep ,Start/
Pause button as well as the rotary switch are locked. Press the two buttons for 2.5 seconds together and buzzer
will beep to release to locking. But cut off the power supply, the kid’s protection is also release to locking. The
kid’s protection will not be cancelled after all procedures are completed.
-
Bubble Removal Function
Bubble Check Function: Redundant bubbles will occur when there is excessive detergent, which will aff ect wash
and rinse eff ects. The procedure will check automatically and one bubble removal procedure will be added
automatically to remove bubbles when excessive bubbles are checked.