Philco PLD 1273 Crown - Příručka (Stránka 8)

EN - 6
04/2015 Copyright © 2015, Fast ČR, a. s.
PART 3: Install Washing Machine
Unpacking the washing machine
Unpack your washing machine and check if there is any damage during the transportation.
Also make sure that all the items (as shown in Page 5) in the attached bag are received.
If there is any damage to the washing machine during the transportation, or any item is missing, please contact
the local dealer immediately.
Dispose the packing materials
The packing materials of this machine may be dangerous to kids. Please dispose them properly and avoid easy
touch by kids. Please dispose the related packing materials according to the relevant local regulations. Please do
no throw the packing materials away together with the other daily living rubbishes.
Remove transport bolts
Before using this washing machine, transport bolts must be removed
from the backside of this machine. Please take the following steps to
remove the bolts:
1. Loosen all bolts with spanner and then remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Select the location
Before installing the washing machine, the location characterized as follows shall be selected:
-
Rigid, dry, and level surface (if not level, please make it level with reference to the following fi gure “Adjust
Leg”)
- Avoid direct sunlight
- Suffi cient ventilation
- Room temperature is above 0 °C
- Keep far away from the heat resources such as coal or gas.
Make sure that the washing machine will not stand on power cord.
Do not install the washing machine on the carpet fl oor.
Adjust Leg
1. When positioning the washing machine, please fi rst check if the
legs are closely attached to the cabinet. If not, please turn them to
their original positions with hand or spanner and tighten the nuts
with spanner.
2. After positioning the washing machine, press four corners on top
cover of washing machine in sequence. If the washing machine is
not stable when being pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing machine. Loosen the
lock nut with spanner and turn the leg with hand until it closely
contacts with the fl oor. Press the leg with one hand and fasten the
nut closely to the cabinet with the other hand.
4. After being locked properly, press four corners again to make sure that they has been adjusted properly. If
it is still unstable, it has to repeat Steps 2 and 3.