Philco PLD 1273 Crown - Příručka (Stránka 9)

EN - 7
04/2015 Copyright © 2015, Fast ČR, a. s.
5. Put a solid cylinder (e.g. pop cans) oppositely on the top cover of the washing machine from in the left,
right, front and back directions. If the cylinder keeps stable, the washing machine is positioned level. If
it rolls, the washing machine is positioned unlevel. The rolling direction is the direction of lower ground
surface. Then, the two legs in this direction shall be raised at the same time until the washing machine is
level. Steps 1~3 are repeated to make the bottom legs closely against the ground and the nuts shall be
locked tightly.
Connect inlet pipe
Connect the inlet pipe as indicated in the fi gure.
For the model which has hot valve, please connect the hot vale to hot
water tap. Energy will decrease automatically for some program.
Install inlet pipe
1. Connect the elbow to tap and fasten it clockwise.
2. Connect the other end of inlet pipe to the inlet valve at the
backside of washing machine and fasten the pipe tightly
clockwise.
NOTE:
After connection, if there is any leakage with hose, then repeat the steps to connect inlet pipe. The most
common type of tap shall be used to supply water. If tap is square or too big, then standard tap shall be
changed.
Place outlet hose
There are two ways to place the end of outlet hose:
1. it beside the water trough.