Philco PLD 1273 Crown - Příručka (Stránka 22)

EN - 20
04/2015 Copyright © 2015, Fast ČR, a. s.
WARNING:
To avoid burning, it shall be done after the hot water inside the machine cools down.
Clean detergent box and grooves
Clean detergent drawer and grooves
1. Press down the arrow location on softener cover inside the drawer.
2. Lift the clip up and take out softener cover and wash all grooves with
water.
3. Restore the softener cover and push the drawer into position.
Clean inlet fi lter
Inlet fi lter shall must be cleaned if there is not any or insuffi cient water in
when the tap is opened.
Clean the tap fi lter:
1. Close the tap.
2. Select any procedure except “Wash” or “Drain” procedure.
3. Press the button “Start/Pause” and keep the procedure running for
about 40 seconds.
4. Remove the inlet pipe from the tap.
5. Use water to wash the fi lter.
6. Reconnect the inlet pipe.
Washing the fi lter in washing machine:
1. Screw
off the inlet pipe from the backside of the machine.
2. Pull out the fi lter with long nose pliers and reinstall it back after being
washed.
3. Reconnect the inlet pipe.
4. Open the tap and make sure there is no water leakage.
5. Close the tap.
NOTE:
Generally, the tap fi lter is washed fi rst and then the fi lter in washing
machine will be washed.
If only the fi lter in washing machine is washed, then the steps 1~3 in
cleaning the tap fi lter shall be repeated.