Part 8: prevention of minor malfunctions, En - 45 – Philco PLD 14961 WD Uživatelská příručka
Stránka 47
EN - 45
02/2013
Copyright © 2013, Fast ČR, a. s.
PART 8: PREVENTION OF MINOR MALFUNCTIONS
All necessary repairs of the washing machine should be performed by an authorised service centre. If it is necessary
to repair your washing machine or you are unable to remedy the malfunction using the information below:
x Disconnect the washing machine from the power socket.
x Shut off the water inlet.
x Contact the nearest authorised service.
MALFUNCTION
POSSIBLE CAUSE
REMEDY
You washing machine
is not working.
It is not connected to a power socket. Connect the power plug to the power socket.
The fuse has burnt out.
Replace the fuse.
A power outage occurred.
Check whether the electricity is working.
You didn't press the Start/pause
button.
Press the Start/pause button.
The program selection dial is in
the STOP position (off ).
Turn the program selection dial to the desired
position.
The washing machine door is not
properly shut.
Close the door properly. You should hear it click in.
Your washing machine
is not fi lling up with
water.
The water inlet is shut off .
Open the water inlet.
The supply hose may be bent.
Check the supply hose.
The supply hose is clogged.
Clean the supply hose fi lters. (*)
The inlet valve fi lter is clogged.
Clean the inlet valve fi lters. (*)
The washing machine door is not
properly shut.
Close the door properly. You should hear it click in.
Your washing machine
is not draining water.
The drain hose is clogged or bent. Check the drain hose.
The pump fi lter is clogged.
Clean out the pump fi lter. (**)
The washing machine
is vibrating.
The washing machine is not levelled. Level the washing machine. (***)
You didn't remove the
transporting screws.
Remove the transporting screws. (****)
There is a small laundry load in
the drum.
This will not damage the washing machine in any
way.
The washing machine is
overloaded or the laundry is
arranged unevenly.
Do not insert more laundry than the
recommended load and check that the laundry
is evenly arranged inside the washing machine.
The washing machine is leaning
against a hard surface.
Avoid installing the washing machine leaning on
a hard surface. When installing the washing
machine, leave a free space of 2 cm between it and
the wall or hard place.
There is an excessive
amount of foam in the
drawer for washing
detergent.
You have used enough washing
detergent.
Press the Start/Pause button. You can prevent
foam from forming by pouring a mixture of half
a spoon of fabric softener and half a litre of water
into the washing detergent drawer.
Press the Start/Pause button again after
5-10 minutes. When you wash again, use the
correct amount of washing detergent.
Unsuitable washing detergent.
Only use washing detergents specially made for
automatic washing machines.