Philco PLD 14961 WD - Příručka (Stránka 49)

EN - 47
02/2013 Copyright © 2013, Fast ČR, a. s.
PART 9: AUTOMATIC MALFUNCTION DETECTION
SYSTEM
Your washing machine is equipped with a system, which during the washing process continually monitors the
correct progress and in the case of any malfunction takes the necessary remedy measures and will at the same
time inform you about the malfunction.
Error codes
Check the door.
POSSIBLE CAUSE Open washing machine door.
SOLUTION
Close the washing machine door.
If the problem continues, turn off the washing machine
disconnect it from the power socket and immediately contact the nearest
authorised service centre.
Error codes
NO WATER SUPPLY
Check the water supply.
POSSIBLE CAUSE Water outage or low water pressure
SOLUTION
- The water supply may be clogged. Check it.
- There may be a water outage. Check it.
- If it is so, switch the program selection dial to the STOP position.
You can select a program and start the washing machine once water supply
is renewed.
- The water pressure may be low.
Check it.
- The supply hose may be bent.
Check it.
- The supply hose may be clogged.
- Clean the supply hose fi lters. (*)
If the problem persists, disconnect the washing machine from the power socket,
shut off the water inlet and contact your nearest authorised service centre.
Error codes
PUMP
Disconnect the washing machine
from the power socket.
POSSIBLE CAUSE
The pump is damaged, the pump fi lter is clogged or the pump electronics are
not working.
SOLUTION
Clean out the pump fi lter (**).
If the problem persists, contact your nearest authorised service centre.