Philco PHS 316 - Příručka (Stránka 13)

EN - 11
© 2012 09/2012
As soon as the temperature decreases to the operating temperature, the "t" symbol will disappear from the
displays and the appliance will switch to the stand-by mode. Then turn on the appliance using the main
power switch
.
Automatic shut-off of the cooktop
The control panel has a preset operating time. If you do not press any button during this preset time, the
appliance will turn off automatically ("0" will be shown on the display for 10 seconds and then the warm
hotplate symbols will appear). The preset operating time depends on the preset temperature. If the hotplate
timer was activated, then the "00" symbol will appear on the display for 10 seconds. Then the timer display
will be turned off .
After the automatic shut-off of the cooktop, turn the cooktop on again using the main power switch and you
can use it again.
Warm hotplate indicator light
After fi nishing cooking there is accumulated heat on the glass ceramic hotplate, which may remain
dangerous even after the cooktop is turned off . The control sensor can calculate, how hot the glass is in the
worst case scenario. If the temperature is higher than 60 °C, the display of the respective hotplate will show
the warm hotplate symbol, after you turn off the cooktop. The warm hotplate indicator light will remain lit
until the temperature falls below 60 °C.
The warm hotplate symbol has a lower priority than other symbols and therefore may be overwritten by
another value, for example when the cooktop is turned off for safety reasons.
If the electrical power supply is interrupted and subsequently renewed, the warm hotplate symbol will be lit
on the hotplate that is still hotter than 60 °C. The display will start fl ashing until the temperature declines or
until you turn on the cooktop again.