Using the boost function, Turning off individual hotplates, Timer function (available depending on the model) – Philco PHS 316 Uživatelská příručka
Stránka 9
EN - 7
© 2012
09/2012
Using the Boost function
All hotplates are equipped with the Boost function.
If the Boost function is activated, the hotplate will switch to maximum power for a preset time, which
depends on the selected temperature setting. The "A" symbol and the set temperature will be intermittently
shown on the display in one second intervals. As soon as the Boost function time elapses, only the set
temperature is shown.
If the Boost function is used, the temperature must be set to 9 from 0 using the
button. After the
temperature is set to 9, it will be intermittently shown on the display with the "A" symbol. This means that
temperature 9 and the Boost function are set.
You can also activate the Boost function by repeatedly pressing the
button up to temperature 9. The
symbol "A" and 9 will intermittently fl ash on the display.
Turning off individual hotplates
You can turn off a hotplate in one of the following ways:
• Press
the and
buttons at the same time.
•
Lower the temperature to 0 by repeatedly pressing the
button.
•
Turn on the timer function for turning off a hotplate.
Timer function (available depending on the model)
It is poss ible to set a maximum of 2 timers simultaneously (one for each hotplate) and also a minute timer,
which is independent of a hotplates that are turned on.
All the timers can only be set in the operating mode. The hotplate timer can be set when the hotplate
temperature is set in the range from 1 - 9. The minute timer can be set without the need to turn on a hotplate.
In order to use both types of timers at the same time, the timer function must be activated using the
button.
Turn on the appliance. Then press the
button once and the system will show the minute timer (no
hotplate indicator is fl ashing and all hotplates are turned off ).
Press the
button again and the cooking zone indicator will start fl ashing. Now the appliance is switched
to the timer setting.
Press the
button again and the timer of the next hotplate can now be set. Repeat the previous step.