Philco PHS 316 - Příručka (Stránka 18)

EN - 16
© 2012 09/2012
Electrical connection
Before connecting the electrical wiring check that:
•
The voltage in dicated on the rating label of the appliance (in the rear part) is the same as the voltage in
your power socket.
• The circuit into which the appliance will be connected must cover the load of the given appliance (see
rating label).
• The power supply must be grounded in accordance with stipulated valid codes and must be in good
condition.
• The circuit breaker to which the appliance is connected must remain easily accessible.
• If neither the respective electrical circuit or circuit breaker are available, it is necessary to have one installed
by a qualifi ed electrician before installing and connecting the appliance.
The electrical wiring connection must be performed according to the illustration below.
3×2.5 mm 2 220 V~
* This appliance must be grounded .
* For this connection the wire type H 05 V V-F should be used.
The electrical wiring connection may only be performed by an authorised service centre or by an electrical
technician registered for this purpose! An incorrect connection will lead to irreparable damage of the device,
which may subsequently not be acknowledged in a warranty claim. Before connecting, have the voltage in
your grid checked to ensure that it conforms to the voltage on the rating label. The consumer's connecting
voltage (230 V against N) must be verifi ed by a technician using a measuring device. The length of the power
cord must be 1.5 m so that you can connect the device prior to moving it towards the wall.
Protective electrical lines must be performed according valid codes and norms.
Wire colours
L1, L2, L3 = outside wires that conduct voltage. As a rule the colours are: black, brown.
N = neutral wire. As a rule the wire colour is blue.
Ensure that the N-connection is correct!
PE = protective wire. The colour of the wire is green – yellow.