Philco PMD 2501 BIX - Příručka (Stránka 8)

EN - 6
05/2013 Copyright © 2013, Fast ČR, a. s.
PART 3: INSTALLATION
1. Make sure that you have removed all packaging materials and advertising labels from inside the appliance.
2. WARNING: Check that the microwave oven is not damaged and that the door and the locks fi t well, that
the gasket seal is not damaged, that the hinges and locks are not destroyed or loosened and that the
inside area is in order. If you discover any damage, please contact an authorised service centre.
3. This microwave oven must be placed on an even, stable surface, that can bear its weight even with food
inserted.
4. Do not install the oven in the vicinity of heat sources, moisture or high humidity, or near fl ammable
materials.
5. For proper operation of the microwave oven it is necessary to provide suffi cient air ventilation. Allow free
space of 20 cm above the top surface of the oven, 10 cm from behind and 5 cm on the sides. Do not cover
or block the openings in the appliance. Do not remove the feet of the microwave oven.
6. Do not use the microwave oven without the glass turning plate, drive assembly and the rotating ring
installed.
7. Make sure that the power cord is not damaged and is not led under the oven or over a hot or sharp surface.
8. The power socket must be freely accessible so that you can disconnect the microwave oven at any time
if necessary.
9. Do not use the microwave oven outdoors.
10. This appliance may be built-in.
Installation procedure
Connect the appliance only to a properly grounded power socket.
If the power socket is not suitable for connecting the plug on the power cord, then it must be replaced
with a suitable power socket by a qualifi ed service technician according to valid local legal codes.
The cabinet into which the appliance is to be installed should not have the rear wall attached in order to
ensure maximum possible air circulation and ventilation.
The minimum installation height is 85 cm
Do not cover the ventilation outlets and inlets.
Do not bend the power cord, do not expose it to excessive pressure and do not damage it in any way.