Philco PEW 6713 - Příručka (Stránka 10)

EN - 8
04/2012 Copyright © 2012, Fast ČR, a. s.
2. Installation of the non-return exhaust fl ap
Install the non-return exhaust fl ap on to the top part of the range hood using 3.5 x 9.5 screws according to
the illustration below.
3.5 x 9.5 screws
3. Drilling mounting holes
Place the installation template against the wall and drill holes in points A, B, and C using a drill bit with a
diameter of 10 mm. To install the chimney, drill holes using a drill bit with a diameter of 6 mm adhering
to the dimensions for the minimum and maximum height. For 80 – 90 cm models drill holes marked G, H
using a drill bit with a diameter of 8 mm.
WARNING!
When drilling the mounting holes used for hanging the range hood, ensure the holes have the
correct diameter. If the holes are drilled incorrectly, then the correct assembly of the range hood
will not be possible.
4. Inserting dowels
Into the drilled holes A, B and C with a diameter of 10 mm, insert dowels with a diameter of 10 mm. Into
the two holes with a diameter of 6 mm, insert dowels with a diameter of 6 mm – see illustration below.
For 80 – 90 cm models into the drilled holes G, H insert dowels with a diameter of 10 mm.
10mm plastic dowel 6mm plastic dowel