Philco PEW 6713 - Příručka (Stránka 21)

EN - 19
04/2012 Copyright © 2012, Fast ČR, a. s.
Models with a 25W light bulb
Unscrew the broken light bulb. Install a new one with the same parameters.
Cleaning
 Aluminium fi lters capture dust and fat from the extracted air.
 It is necessary to regularly wash these fi lters, ideally once a month, depending on the level of use. Wash the
fi lters in water with dishwashing detergent, or you may place the fi lters in a dishwasher and wash them
using a gentle program (max. 60°C).
 Take out the aluminium fi lters by pressing the clip.
 After cleaning allow the aluminium fi lters to dry thoroughly before reinstalling them.
 Wipe the outer surface of the range hood with a clean damp wiping cloth lightly dipped in water with
a small amount of dishwashing detergent. Then wipe dry.
 Avoid electrical parts coming into contact with water or another liquid.
 For cleaning you can also use special agents for the maintenance and cleaning of INOX surfaces (applies
only for models with an INOX surface treatment).
Cleaning the aluminium fi lters
Models with digital controls – 3 speeds
Aluminium fi lters need to be cleaned when "C" (depending on the model) appears on the display, e.g. every
2 – 3 weeks (depending on the level of use).
Clean the fi lters according to the above mentioned instructions and after reinstalling them press and hold
down the I fan button for 3 seconds until the "C" symbol (depending on the model) disappears from the display.
The symbol "E" (depending on the model) will appear on the display, which means that the appliance is ready
for operation.
If you wish to use the appliance without clearing the "C" symbol (depending on the model), press the I button
to start extraction for 1 second, then the "C" symbol (depending on the model) will appear again and the motor
will continue running.
Models with digital controls – 5 speeds
The aluminium fi lters need to be cleaned when "C" appears on the display (depending on the model).
Clean the fi lters according to the above mentioned instructions and after reinstalling them press and hold
down the fan button for 3 seconds until the "C" symbol (depending on the model) disappears from the display.
The symbol "E" (depending on the model) will appear on the display, which means that the appliance is ready
for operation.
If you wish to use the appliance without clearing the "C" symbol (depending on the model), press the fan
button to start extraction for 1 second, then the "C" symbol (depending on the model) will appear again and
the motor will continue running.
NOTE:
The "C" symbol (depending on the model) appears on the display after approximately 60 hours
of operation.