Philco PW 166 - Příručka (Stránka 10)

EN - 8
08/2013 Copyright © 2013, Fast ČR, a. s.
PART 3: INSTALLATION
Transport and unpacking
If the appliance is transported in a horizontal position the oil from the compressor may leak into the cooling
circuit. For this reason, allow the appliance to rest in a vertical position for 12 hours before turning it on, so that
the oil fl ows back into the compressor.
Remove the external packaging, remove the protective plastic fi lm from the surface of the appliance
(if used) and clean the external parts of the appliance with an agent designed for this purpose. Do
not use steel wool or any coarse agents, which could irreparably damage the surface of the appliance.
Carefully remove all papers and adhesive tape from the appliance, the door and other parts packed
in polystyrene. Remove documents and accessories from inside the appliance.
The packaging material is recyclable and is marked with a recycling symbol. For disposal follow the local
regulations. Packaging materials (plastic bags, polystyrene parts, etc.) must be kept out of the reach of children,
because they present a possible source of danger.
Carefully inspect the appliance. If you discover any defects, stop the installation and contact the vendor.
As a rule the appliance comes with:
-
user's manual;
- 15 slide-out racks (14 with a wheel system) on the PW 166 model; 14 slide-out racks (13 with a wheel
system) on the PW 166D model; 9 pull-out racks (7 with a wheel system) on model PW96.
- 2 keys;
- accessories for changing the door opening direction.
Operating conditions
Proper operation of the appliance is guaranteed only if the following conditions are met:
The temperature in the room where the appliance is located conforms to the climate class stated on the
appliance's rating label.
Maximum ambient relative humidity: 90%.
The appliance must be placed at a suffi
cient distance from heat sources (e.g. baking ovens, central heating,
direct sunlight, etc.).
The appliance must be located in such a place that it is protected against the eff ects of weather.
Regular maintenance is performed according to the instructions in this user's manual.
The ventilation openings in the cover of the appliance must not be covered by anything.
Correct installation (e.g. levelling, the capacity of the system corresponds to the specifi cations on the rating
label of the appliance).
Table – Climatic class
Climatic class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C