Fenix ZY-203A 1800 W - Příručka (Stránka 8)

Please read the information contained in these instructions carefully. It provides important advice regarding
the safe installation, use and maintenance of the unit . These instructions should be kept in a safe place and
passed on to the new owner should the unit be resold.
The hand-dryer contains a heated fan, which emits a diagonal jet of warm air downwards. The hand - dryer is
fitted with an infrared sensor which automatically switches the unit on when hands are placed at the under-
side of the unit. Once hands have been removed, the fan automatically switches off after a short delay. The
hand-dryer does not, therefore, require an integrated power switch.
The installation, electrical connection and first operation of this appliance should be carried out by a quali-
fied installer.
The manufacturer will accept no liability for any injury or damage resulting from failure to observe the
following:
•
Ensure packing materials are disposed of properly.
• Any damage to the hand-dryer on delivery should be reported to the supplier before the unit is connec-
ted.
•
To ensure the safe operation of the hand dryer, it should only be installed and connected by a trained
specialist in accordance with the instructions contained in this booklet.
•
The hand-dryer should only be used for the purpose for which it is intended.
• Repairs to the hand-dryer should only be carried out by a trained specialist.
• Units which are no longer fit for service must be disposed of immediately.
•
For this purpose, pull out mains plug and disconnect the dead supply lead (e.g. by cutting it). The unit
should then be disposed of properly.
During operation temperatures of over 90°C can occur at the warm air exit grille. In the event of over heating
the temperature safety cut out switches off the heating element and the fan continues to run in cooling mode.
The heating element switches back on after approximately two minutes.
Ensure that the air inlet and exit grilles on the underside and rear of the dryer are always kept open.
Technical data
Power 1 800 W
Power supply 220 - 240 V / 50 Hz
Temperature of hot air 60°C ± 20°C
Speed 15m/s
Switch area 14cm ± 3cm
Time delay méně než 5 s
Weight 2,8kg
Dimensions
275 x 265 x 255 mm